provisional data sheet. type E0460QC45E issue a1 page 1 of 9 june, 2017 date: - 2 june 2017 data sheet issue: a1 advance data high power sonic frd type E0460QC45E absolute maximum ratings voltage ratings maximum limits units v rrm repetitive peak reverse voltage, (note 1) 4500 v v rsm non - rep etitive peak reverse voltage, (note 1) 4600 v v r(d.c.) maximum reverse d.c. voltage (note 1) 2800 v other ratings (note 6) maximum limits units i f(av)m mean forward current, t sink =55c, (note 2) 533 a i f(av)m mean forward current. t sink =100c, (note 2) 328 a i f(av)m mean forward current. t sink =100c, (note 3) 173 a i f(av)m mean forward current. t sink =100c, (note 4) 227 a i f(rms) nominal rms forward current, t sink =25c, (note 2) 1007 a i f(d.c.) d.c. forward current, t sink =25c, (note 5) 897 a i fs m peak non - repetitive surge t p =10ms, v rm =60%v rrm , (note 6) 6800 a i fsm2 peak non - repetitive surge t p =10ms, v rm 10v, (note 6) 7480 a i 2 t i 2 t capacity for fusing t p =10ms, v rm =60%v rrm , (note 6) 231 10 3 a 2 s i 2 t i 2 t capacity for fusing t p =10ms, v rm 10v, (note 6) 280 10 3 a 2 s p rr maximum non - repetitive peak reverse recovery power, (note 8) 1.8 mw t j op operating temp erature range - 40 to +140 c t stg storage temperature range - 40 to +150 c notes: - 1) de - rating factor of 0.13% per c is applicable for t j below 25c. 2) double side cooled, single phase; 50hz, 180 half - sinewave. 3) anode side cooled, single phase; 50hz, 180 half - sinewave. 4) cathode side cooled, single phase; 50hz, 180 half - sinewave. 5) double side cooled. 6) half - sinewave, 140c t j initial. 7) current (i f ) ratings have been calculated using v t0 and r t (see page 2) 8) t j =t jop , i f =460a, di/dt=1000a/s v r =2800v and l s =250nh. test circuit and sample waveform are shown in diagram 1. igbt type t0510vb45e used as switch.
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 2 of 9 june, 2017 characteristics parameter min. typ. max. test conditions (note 1) units v fm maximum peak forward voltage - 3.25 3.45 i fm =460a v - - 4.85 i fm =920a v t0 threshold voltage - - 2.246 current range 533a - 1599a (note 2) v r t slope resistance - - 2.716 m ? v t01 threshold voltage - - 2.15 current range 460a ? 1380a v r t1 slope resistance - - 2.83 m ? v frm maximum forward recovery voltage - - 540 di/dt = 3000a/s v - - 330 di/dt = 3000a/s, t j =25c i rrm peak reverse current - - 90 rated v rrm ma - - 2 rated v rrm , t j =25c q rr recovered charge - 685 755 i fm =460a, t p =1ms, di/dt=1000a/s, v r =2800v, 50% chord (note 3) c q ra recovered charge, 50% chord - 265 - c i rm reverse recovery current - 460 510 a t rr reverse recovery time, 50% chord - 1.15 - s e rr reverse recovery energy loss - 1.32 1.45 j r thjk thermal resistance, junction to heatsink - - 0.0274 double side cooled k/w - - 0.0 676 anode side cooled k/w - 0.0467 cathode side cooled f mounting force 12 - 20 (note 4) kn w t weight - 300 - g notes: - 1) unless otherwise indicated t j =140c. 2) v t0 and r t were used to calculate the current ratings illustrated on page one. 3) figures 3 - 7 were compiled using these conditions. test circuit and sample waveform are shown in diagram 1. 4) for clamp f orces outside these limits, please consult factory.
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 3 of 9 june, 2017 additional information on ratings and characteristics 1.0 de - rating factor a blocking voltage de - rating factor of 0.13% per c is applicable to this device for t j below 25c. 2.0 abcd constants thes e constants (applicable only over current range of v f characteristic in figure 1) are the coefficients of the expression for the forward characteristic given below: f f f f i d i c i b a v ? + ? + ? + = i g l s d.u.t (i) q ra is based on 50% i rm chord as shown in figure below. (ii) q rr is based on a 20 s integration time. i.e. = s rr rr dt i q t t factor k =
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 4 of 9 june, 2017 4.0 reverse recovery loss the following procedure is recommended for use where it is necessary to include reverse recovery loss. from waveforms of recovery current obta ined from a high frequency shunt (see note 1) and reverse voltage present during recovery, an instantaneous reverse recovery loss waveform must be constructed. let the area under this waveform be e joules per pulse. a new sink temperature can then be eval uated from: [ ] ) ( ) ( hs j th max j sink r f k e t t ? ? + ? ? = f e w w original tot ? + = ) ( ) ( note 1 - reverse recovery loss by measurement this device has a low reverse recovered charge and peak reverse recovery current. when measuring the charge, care must be taken to ensure that: (a) ac coupled devi ces such as current transformers are not affected by prior passage of high amplitude forward current. (b) a suitable, polarised, clipping circuit must be connected to the input of the measuring oscilloscope to avoid overloading the internal amplifiers by the relatively high amplitude forward current signal. (c) measurement of reverse recovery waveform should be carried out with an appropriate critically damped snubber, connected across diode anode to cathode. the formula used for the calculation of this snubber is shown below: dt di c v r s r ? ? = 4 2 where: v r = commutating source voltage c s = snubber capacitance r = snubber resistance 5.0 computer modelling parameters 5.1 device dissipation calculations t av t t t av r ff w r ff v v i ? ? ? ? ? + + ? = 2 2 2 0 0 2 4 where v t0 = 2.24 6v , r t =2.716 m ?
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 5 of 9 june, 2017 ff = form factor (normally unity for fast diode applications) k max j th av t t t r t w ? = ? ? = ) ( 5.2 calculation of v f using abcd coefficients the forward characteristic i f vs v f , on page 6 is represented in two ways; (i) the well established v t0 and r t tangent used for rating purposes and ( ( i i i i ) ) a set of constants a, b, c, and d forming the coefficients of the representative equation for v f in terms of i f given below: f f f f i d i c i b a v ? + ? + ? + = ) ln( the constants, derived by curve fitting software, are given in th is report for both hot and cold characteristics. the resulting values for v f agree with the true device characteristic over a current range, which is limited to that plotted. 25c coefficients 140c coefficients a 0.658802329 0.509419974 b 0.2476167 0.102603 c 1.66895510 -3 1.36540210 -3 d 0.02122774 0.07848953
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 6 of 9 june, 2017 curves figure 1 ? forward characteristics of limit device figure 2 ? maximum forward recovery voltage figure 3 ? maximum recovered charge, q rr figure 4 ? maximum recovery char ge, q ra (50% chord) 10 100 1000 10000 1 2 3 4 5 6 7 8 maximum instantaneous forward voltage - v fm (v) instantaneous forward current - i fm (a) 140 c 25 c E0460QC45E issue a1 10.0 100.0 1000.0 100 1000 10000 rate of rise of forward current - di/dt (a/s) maximum forward recovery voltage - v frm (v) t j = 140 c E0460QC45E issue a1 140c 25c 100 1000 100 1000 10000 commutation rate - di/dt (a/s) total recovered charge - q rr (c) t j = 140 c 200a 300a E0460QC45E issue a1 460a 100 1000 100 1000 10000 commutation rate - di/dt (a/s) recovered charge - q ra , 50% chord (c) t j = 140c 460a 200a E0460QC45E issue a1 300a
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 7 of 9 june, 2017 figure 5 - maximum reverse current, i rm figure 6 ? maximum recovery time, t rr (50% chord) figure 7 ? typical reverse recovery energy per pulse figure 8 ? safe operating area 100 1000 100 1000 10000 commutation rate - di/dt (a/s) reverse recovery current - i rm (a) t j =140 c 460a 300a 200a E0460QC45E issue a1 0.1 1 10 100 1000 10000 commutation rate - di/dt (a/s) recovery time - t rr , 50% chord (s) t j = 140 c 460a 300a 200a E0460QC45E issue a1 0 1 10 100 1000 10000 commutation rate - di/dt (a/s) reverse recovery energy per pulse - e r (j) measured without snubber 460a 300a t j = 140 c v r = 2800v E0460QC45E issue a1 200a 0 200 400 600 800 1000 0 1000 2000 3000 4000 5000 reverse recovery voltage - v r (v) reverse recovery current - i r (a) t j = 140c di/dt = 1000a/s l s < 200nh E0460QC45E issue a1
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 8 of 9 june, 2017 figure 9 ? transient thermal impedance figure 10 ? maximum surge and i 2 t ratings 1000 10000 100000 total peak half sine surge current - i fsm (a) 1.0e+05 1.0e+06 1.0e+07 maximum i 2 t (a 2 s) 1 3 5 10 1 5 10 50 100 duration of surge (ms) duration of surge (cycles @ 50hz) i fsm : v r =60% v rrm t j (initial) = 140c i 2 t: v r =60% v rrm i fsm : v rrm 10v i 2 t: v rrm 10v E0460QC45E issue a1
high power sonic frd type E0460QC45E provisional data sheet. type E0460QC45E issue a1 page 9 of 9 june, 2017 outline drawing & ordering information 100a375 ordering information (please quote 10 digit code as below) e0460 qc 45 e fixed type code fixed outline code fixed voltage code v rrm /100 45 fixed code, product series order code: E0460QC45E ? 4500v v rrm , 26mm clamp height capsule. ixys semiconductor gmbh edisonstra?e 15 d - 68623 lampertheim tel: +49 6206 503 - 0 fax: +49 6206 503 - 627 e - mail: marcom@ixys.de ixys uk westcode ltd langley park way, langley park, chippenham, wiltshire, sn15 1ge. tel: +44 (0)1249 444524 fax: +44 (0)1249 659448 e - mail: sales@ixysuk.com ixys corporat ion 1590 buckeye drive milpitas ca 95035 - 7418 tel: +1 (408) 457 9000 fax: +1 (408) 496 0670 e - mail: sales@ixys.net www.ixysuk.com www.ixys.net ixys long beach ixys long beach, inc 2500 mira mar ave, long beach ca 90815 tel: +1 (562) 296 6584 fax: +1 (562) 296 6585 e - mail: service@ixyslongbeach.com the information contained herein is confidential and is protected by copyright. the information may not be used or disclosed except with the written permission of and in the manner permitted by the proprietors ixys uk westcode ltd. in the interest of product improvement, ixys uk westcode ltd reserves t he right to change specifications at any time without prior notice. devices with a suffix code (2 - letter, 3 - letter or letter/digit/letter combination) added to their generic code are not necessarily subject to the conditions and limits contained in this r eport. ? ixys uk westcode ltd.
|
