telefon: +49 (0) 6135 7026 -0 telefax: +49 (0) 6135 931070 www.peak-electronics.de info@peak-electronics.de ppm-series ppmxx-x-xxdlf 5 - 20 w ac/dc converter triple output input specifications input voltage range 85- 264vac, 120- 370vdc input frequency 47- 63hz input current ppm05 ppm10 ppm15 ppm20 ppm25 110vac 230vac 120ma , typ. 70ma , typ. 230ma , typ. 120ma , typ. 250ma , typ. 140ma , typ. 330ma , typ. 180ma , typ. 420ma , typ. 230ma , typ. inrush current ppm05 ppm10 ppm15 ppm20/ppm25 110vac 230vac 10a, typ. 20a, typ. 10a, typ. 20a, typ. 10a, typ. 20a, typ. 16a, typ. 30a, typ. external input fuse(recommended) ppm05 ppm10/ppm15 ppm20/ppm25 1a/250v slow blow 2a/250v slow blow 3.15a/250v slow blow output specifications voltage set accuracy 2%(main out) input variation 0.5% (main output) 1.5% (supplement output) load variation (10-100%) isolated triple out put (balanced load) vo1 3% (main output) vo2 5% (supplement output) ripple& noise(p-p) 20mhz bandwidth 100mv short circuit protection continuous, and auto resume over current protection 110% io over output voltage protection 3.3 / 5vdc models 9vdc model 12 / 15vdc model s 24vdc model 48vdc model 6.5vdc 12vdc 20vdc 30vdc 60vdc general specifications temperature ranges operating : power derating above 55c: storage: case temperature: -25c to +70c 3.75% / c -25c to +105c +90c max weight ppm05, ppm10, ppm15, ppm20/25 ~50g, ~70g , ~80g, ~120g hold-up time (vin=230vac) 80m s(typ.) humidity (non condensing) 85%(max) temperature coefficient 0.02% /c switching frequency 150khz max efficiency see table i/o-isolation voltage 3000vac/1min leakage current 0.3ma rms typ.. 230vac/50hz case material ul 94v-0 rated install pcb mtbf >200,000h @25c rohs compliant soldering 260c / max. 10 sec.
note: unit: mm pin section: 1.00mm pin tolerances: +/- 0.1mm general tolerances: +/- 0.5mm ppm-series ppmxx-x-xxdlf 5 - 20 w ac/dc converter triple output examples of partnumbers/modelcode part no. power (watt) input current (ma, typ.) 110v / 230v output (vo1 / io1) output (vo2 / io2) ripple and noise (typ.) efficiency (% min.) ppm05-a-0505dlf 5 120 / 70 5v / 800ma 5v / 100ma 50mv 76 ppm05-a-0512dlf 5 120 / 70 5v / 600ma 12v / 100ma 50mv 76 ppm05-a-0515dlf 5 120 / 70 5v / 600ma 15v / 80ma 50mv 76 ppm05-a-0524dlf 5 120 / 70 5v / 600ma 24v / 50ma 50mv 76 PPM10-B-0505DLF 10 230 / 120 5v / 1200ma 5v / 400ma 50mv 78 ppm10-b-0512dlf 10 230 / 120 5v / 1000ma 12v / 200ma 50mv 78 ppm10-b-0515dlf 10 230 / 120 5v / 900ma 15v / 200ma 50mv 78 ppm10-b-0524dlf 10 230 / 120 5v / 1000ma 24v / 100ma 50mv 78 ppm15-c-0505dlf 15 250 / 140 5v / 2000ma 5v / 500ma 50mv 80 ppm15-c-0512dlf 15 250 / 140 5v / 2000ma 12v / 200ma 50mv 80 ppm15-c-0515dlf 15 250 / 140 5v / 1800ma 15v / 200ma 50mv 80 ppm15-c-0524dlf 15 250 / 140 5v / 2000ma 24v / 100ma 50mv 80 ppm20-d-0505dlf 20 330 / 180 5v / 2500ma 5v / 500ma 50mv 82 ppm20-d-0512dlf 20 330 / 180 5v / 2000ma 12v / 400ma 50mv 82 ppm20-d-0515dlf 20 330 / 180 5v / 2000ma 15v / 300ma 50mv 82 ppm20-d-0524dlf 20 330 / 180 5v / 2000ma 24v / 200ma 50mv 82 other specifications please enquire. dimensions / pinning no. ppmxx- a no. ppmxx- b no. ppmxx- c no. ppmxx- d a 12.5 a 17.5 a 17.5 a 20.0 b 48.5 b 55.0 b 62.0 b 70.0 c 40.5 c 47.0 c 54.0 c 62.0 d 4.0 d 5.0 d 5.0 d 5.75 e 16.0 e 20.0 e 20.0 e 23.0 f 36.0 f 45.0 f 45.0 f 48.0 g 20.5 g 20.5 g 22.5 g 23.5 h 6.0 h 6.0 h 6.0 h 6.0 # triple out 1 ground 2 ac (n) 3 ac (l) 4 - v output 1 5 + v output 1 6 - v output 2 7 com 8 + v output 2 trim omitted pinning ppmxx-x-xxdlf
ppm-series ppmxx-x-xxdlf 5 - 20 w ac/dc converter triple output app notes remarks : 1.ripple and noise were measured by the method of p arallel lines; 2.unless otherwise specified, all specifications ab ove are measured at rated input voltage and rated o utput load, ta=25c, humidity < 75%; 3.all specifications stated in this datasheet are s ubject to the above listed model only. for specific ations of non-standard model, please contact our technical support team. parallel lines measure 2 c1 c2 copper sheet load 25.4m m 25.4m m connect oscillograph probe fuse typical applications ppm-series ppmxx-x-xxelf (single output) l +vo -vo l n n c1 c2 fuse fg fg tvs 1 rl nt c ppmxx-x-xxzslf (isolate twin output) + - c1 c 4 c3 c 2 - vo 1 vo 2 tv s1 tv s2 r l rl fuse l ln n fg fg nt c + ppmxx-x-xxzlf (dual output) fuse +vo l ln -vo n com c 4 c 2 c 1 c3 r l tvs1 tv s2 rl fg fg ntc ppmxx-x-xxdlf (triple output) +vo1 -vo2 com c6 c2 c5 c1 +vo2 tv s1 tvs3 rl rl c4 c3 tvs 2 rl n n fg fg fuse l l n tc -vo1 external typical value vout c1/c3/c5 c2/c4/c6 tvs 3.3v 330 - 10 00uf/16v p6ke6.8a 5v 330 - 1000uf/16v p6ke6.8a 12v 47 - 220uf/25v p6ke16a 15v 47 - 220uf/25v p6ke20a 24v 10 - 120uf/35v p6ke33a 48v 10 - 68uf/63v 0.1uf/50-100v (ceramic capacitor) p6ke62a remarks 1.output filtering capacitor c5, c3 and c1 are elec trolytic capacitor. it is recommended to use high f requency and low resistance electrolytic capacitor. for capa citance and current of the capacitor please refer t o suppliers? specifications. voltage derating of capa citor should be 80% or above. c2, c4 and c6 elim inate high frequency noise. tvs is a recommended componen t to protect post-circuits (when converter fails). 2. external input ntc is recommended to use 5d-9 (o nly ppm10 model and ppm15 model) specification can be changed without notice. copyright peak electronics gmbhcs rev old: jan. 08 rev new: oct. 08 changed: new models
|