catalog 1308638 dimensions are in inches and dimensions are shown for usa: 1-800-522-6752 south america: 55-11-3611-1514 revised 8-05 millimeters unless otherwise reference purposes only. canada: 1-905-470-4425 hong kong: 852-2735-1628 specified. v alues in brackets specifications subject mexico: 01-800-733-8926 japan: 81-44-844-8013 www.tycoelectronics.com are metric equivalents. to change. c. america: 52-55-5-729-0425 uk: 44-141-810-8967 circular connectors 74 marc 63 series connectors marc 63 series connectors rmd63 performance data marc 63 series connectors,0 rmd63 series meet or exceed the performance requirements of specification mil-c- 38300a (usaf) as detailed in the m38300a (usaf) military specification sheets covering the marc 53 series connectors. tyco electronics can supply detailed, cross reference information. marc 63 series connectors, rmd63 series meet the following selected test parameters as specified below: description test requirements contact retention contacts are to withstand 15 lbs. [66.72 n] axial load and rmd contacts 10 lbs. [44.48 n] axial load without axial displacement in excess of 0.012 [.305] or damage to contacts or inserts when the axial load is applied to the mating end of the contacts in unmated plugs and receptacles at a rate of approximately 1 lb/sec. [4.45 n]. contact resistance the potential drop across normally mated contacts shall not exceed 25 mv under room ambient and high temperature service conditions when measured as specified in mil-c-26636, fig. 2, with maximum rated current. dielectric withstanding voltage, no evidence of dielectric breakdown or flashover when mated and unmated altitude and sea level plugs are subjected to 645 and 180 volts rms, respectively, at altitudes up to 110,000 [33,528 m] feet and 1000 volts rms at sea level. insulation resistance, insulation resistance of mated plugs and receptacles shall be 5000 megohms, room and high t emp. minimum, at r oom temperature and 1000 megohms, minimum, at 257 [+125] when measured per mil-std-202, method 302, test condition b. coupling and uncoupling plugs and r eceptacles shall withstand up to 500 cycles of engagement and separation without detrimental damage to plugs or r eceptacles or not satisfying subsequent tests of mil-c-38300. fluid immersion mating and unmating forces shall not exceed 27 lbs. [120.10 n], maximum, (15 shell size) after fully wired plugs and receptacles are immersed for 20 hours, each, in hydraulic fluid (mil-h-5606) and high temperatur e lubricating oil (mil-l-9236) followed by a one-hour dr y . sweep vibration, mated mated connectors shall show no circuit interruptions greater than one micr osecond during 12 hours vibration to include six sweeps in each axis at extreme temperatures of -85 [--5? and 257? +125?] er mil-std-202- method 204, t est condition d. post inspection shall show no detrimental crack - ing, br eaking, or loosening of par ts. moistur e resistance the insulation r esistance of mated connectors shall exceed 1000 megohms after subjection to moisture resistance testing per mil-std-202, method 106, as amended by mil-c-38300. altitude breathing the insulation resistance of wired and mated connectors shall be 5000 megohms, minimum, and ther e shall be no flashover or br eakdown at test voltage of 1000 volts rms after the third cycle and while immersed in 5% salt water solution at 68 [20? and room ambient pressure at 68 [20?. salt spray unmated plugs and receptacles shall show no excessive corrosion which would detrimentally affect the electrical and mechanical performance of the connectors after subjection to 24 hours exposur e to salt spray atmosphere per mil-std-202, method 101.
catalog 1308638 dimensions are in inches and dimensions are shown for usa: 1-800-522-6752 south america: 55-11-3611-1514 revised 8-05 millimeters unless otherwise reference purposes only. canada: 1-905-470-4425 hong kong: 852-2735-1628 specified. v alues in brackets specifications subject mexico: 01-800-733-8926 japan: 81-44-844-8013 www.tycoelectronics.com are metric equivalents. to change. c. america: 52-55-5-729-0425 uk: 44-141-810-8967 circular connectors 75 c i r c u l a r c o n n e c t o r s 3 marc 63 series connectors (continued) part number and ordering information typical part number connector part numbers indicate size, shape, insert l ayout, type of seal, style of contact and polarization. n ote: p in or socket (power or coaxial) c ontacts may be used in either plugs or receptacles. however, it is recom- mended that pins be placed in the r eceptacle when possible to take a dvantage of our ?coop-proof design. (1) for polarizing key positions see marc 53 series connectors. (2) for contact arrangements see marc 53 series connectors. note: if p or s does not appear in the numbering system, no contacts will be supplied with order (order separately). configurations md63-06e/rmd63-06e straight plug, bayonet coupling, environmental and non-environmental (mates with receptacles 02, 00 and 01) shell dimensions size a b (max.) c (max.) 9 .813 1.000 1.288 20.65 25.4 32.72 12 1.000 1.000 1.288 25.40 25.4 32.72 15 1.125 1.000 1.288 28.58 25.4 32.72 18 1.594 1.000 1.288 40.49 25.4 32.72 m d63 06 e 15 61 s n (***) modification designator when applicable (see page 77) polarizing position (1) n, 1, 2, 3, 4, etc. . . . p pin power contact s socket power contact insert arrangement number (2) shell size o.d. of receptacle barrel to nearest 1/16 inch e environmentally sealed h hermetic seal (receptacle only). single hole mntng. 00 receptacle line cord recept. 01 box mntng. recpt. 02 straight plug, bayonet 06 quick disconnect series md63 or rmd63 style a master polarizing keyway b c .093 [2.36] max.
catalog 1308638 dimensions are in inches and dimensions are shown for usa: 1-800-522-6752 south america: 55-11-3611-1514 revised 8-05 millimeters unless otherwise reference purposes only. canada: 1-905-470-4425 hong kong: 852-2735-1628 specified. v alues in brackets specifications subject mexico: 01-800-733-8926 japan: 81-44-844-8013 www.tycoelectronics.com are metric equivalents. to change. c. america: 52-55-5-729-0425 uk: 44-141-810-8967 circular connectors 76 marc 63 series connectors (continued) configurations (continued) md63-02e/rmd63-02e r eceptacle, box mounting, e nvironmental and non- e nvironmental (mates with plug, type 06) shell dimensions s ize abc d 9 .875 .662 .562 .693-.697 2 2.23 16.81 14.27 17.60-17.70 12 1 .000 .786 .75 .881-.885 25.40 19.96 19.05 22.38-22.48 1 5 1.125 .906 .875 1.006-1.011 28.58 23.01 2 2.23 25.55-25.68 1 8 1 .344 1.062 1.125 1.250-1.260 3 4.14 26.97 28.58 30.48-32.00 panel cutout md63-00e/rmd63-00e receptacle, single hole mounting, envir onmental and non-environmental (mates with plug, type 06) panel cutout shell dimensions size a b c d e f t (class 2a) 9 .813 .75 1.360 .669-.673 .693-.697 .562 1 1/16-32un 20.65 19.05 34.54 16.99-17.09 17.60-17.70 14.27 12 1.000 .937 1.360 .850-.856 .881-.885 .75 7/8-28un 25.40 23.80 34.54 21.59-21.74 22.38-22.48 19.05 15 1.125 1.062 1.360 .975-.979 1.006-1.010 .875 1-28un 28.58 26.97 34.54 24.76-24.87 25.55-25.65 22.23 18 1.625 1.375 1.360 1.212-1.216 1.251-1.255 1.125 1-1/4-28un 41.28 34.93 34.54 30.78-30.88 31.78-31.88 28.58 md63-01e/rmd63-01e receptacle, line cor d, envir onmental (mates with plug, type 06) shell dimensions size a b (max.) c 9 1.360 .703 .562 34.54 17.86 14.27 12 1.360 .891 .75 34.54 22.63 19.05 15 1.360 1.016 .875 34.54 25.81 22.23 18 1.360 1.203 1.125 34.54 30.56 28.58 .375 [9.53] max. panel thickness for rear mount applications. b typ. a typ. c hex. .093 [2.36] 1.360 [ 34.54] .0 52C .072 [ 1.32C . 83] .065C.08 5 [1.65 C2. 16] ma x. d .110 C .130 [2.79 C3.302] d i a . 4 holes m a ster pol arizing key b hex. a hex. f hex. c t thread .093 [2.36] . 125 [3.18] max. d e master polarizing key b master polarizing key c hex. a .093 [2.36] max.
catalog 1308638 dimensions are in inches and dimensions are shown for usa: 1-800-522-6752 south america: 55-11-3611-1514 revised 8-05 millimeters unless otherwise reference purposes only. canada: 1-905-470-4425 hong kong: 852-2735-1628 specified. v alues in brackets specifications subject mexico: 01-800-733-8926 japan: 81-44-844-8013 www.tycoelectronics.com are metric equivalents. to change. c. america: 52-55-5-729-0425 uk: 44-141-810-8967 circular connectors 77 c i r c u l a r c o n n e c t o r s 3 marc 63 series connectors (continued) accessories cable clamps shell size part no. a b t thread 9 086-0175-00n1 .704 .750 1/2-20unf-2a 1 7.88 19.05 1 2 086-0176-00n1 . 773 .932 1 1/16-24unef-2a 19.63 23.67 1 5 086-0177-00n1 .829 1.078 1 3/16-20unef-2a 2 1.06 27.38 18 086-0178-00n1 . 890 1.250 1-28un-2a 2 2.61 31.75 shell size p ar t no. a b (max.) c (max.) d t thread 9 086-0179-00n1 .737 .600 1.100 .879 1/2-20unf-2a 18.72 15.24 27.94 22.32 12 086-0180-00n1 .913 .785 1.250 1.067 11/16-24unef-2a 23.19 19.94 31.75 27.10 15 086-0181-00n1 1.048 .962 1.469 1.233 13/16-20unef-2a 26.62 24.43 37.31 31.21 18 086-0182-00n1 1.225 1.185 1.550 1.550 1-28un-2a 31.12 30.10 39.37 39.37 s traight a ngle protective covers shell receptacle part no. plug part no. dimensions size w ithout chain w ith chain w ithout chain with chain a b c d 9 086-0253-00p2 086-0257-00l6 086-0261-00f5 086-0265-00l6 .813 .950 .813 .913 20.65 24.13 20.65 23.19 12 086-0254-00p2 086-0258-00l6 086-0262-00f5 086-0266-00l6 1.000 .950 1.000 .913 25.40 24.13 25.40 23.19 15 086-0255-00p2 086-0259-00l6 086-0263-00f5 086-0267-00l6 1.125 .950 1.125 .913 28.58 24.13 28.58 23.19 18 086-0256-00p2 086-0260-00l6 086-0264-00f5 086-0268-00l6 1.594 .950 1.594 .913 40.49 24.13 40.49 23.19 plastic protective covers also available; consult t yco electronics. modifications w e offer a unique modifica- tion system which provides alteration of standard marc 63 series connectors to include special finishes, accessories, and custom quality assurance provisions processing, testing, serialization, traceability. consult your sales representative or tyco electronics for addition- al modification information. standard modifications include: (801): marc 63 series connector , electr oless nickel finish (803): marc 63 series connector including cable clamp, straight type (804): marc 63 series connector including cable clamp, right- angle type . 156 [3.96] .225 [5.72] m ax. a t thread b d c .156 [3.96] .225 [5.72] max. t thread b a a b c d
|
