i n t e r f a c e s b u s i n t e r f a c e c o n v e r t e r s i n f o m a in ch a r ac t er is t ic s www.trinamic.com C for detailed information and datasheets 1 0 m m o r d e r c o d e d e s c r i p t i o n tmc USB-2-X v2 usb interface converter (with usb cable) the engineers ?swiss army knife for serial bus systems the USB-2-X device is an interface converter that is equipped with a can interface, an iic interface, a lin interface, an spi interface and an rs-485 interface. it is connected to the pc via an usb interface. the USB-2-X device is mainly designed for use with some of the trinamic evaluation kits, but it can also be used in any other purpose where a connection between a pc and a can interface, an iic interface, a lin interface, an spi interface or an rs485 interface is needed. the software sup - plied with this product can be used with every version of the windows operating system that supports usb (windows 98, windows me, windows 2000, windows xp). the USB-2-X device can be connected to usb 1.1 or usb 2.0 hosts and supports the full bitrate of 12mbit/s. it is fully powered by the bus, so no extra power supply is needed. u s b - 2 -x u s b t o c a n , i i c , r s 4 8 5 , s p i , l i n i n t e r f a c e c o n v e r t e r u s b host interface connection to usb 1.1 or usb 2.0 hosts possible (a cable is included) usb full speed device (12mbit/s) bus powered (no extra power supply needed) c a n can 2.0a and 2.0b compatible standard (11 bit) and extended (29 bit) identifier possible transceiver: iso 11898 compatible maximum bit rate: 1mbit/s 120 ohms termination resistor can be activated with a jumper l i n compatible with lin specification rev 1.3 up to 20kbit/s industry standard transceiver i 2 c single master up to 400kbit/s 7-bit addressing r s - 4 8 5 half duplex communication mode industry standard 75176 transceiver 2400, 9600 and 19200 bps supported s pi master functionality user defined bit rate up to 3.7mbit/s ro h s compliant ? ? ? ? ? ? ? usb2x can spi rs - 485 usb iic lin 63
|
