12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation notes: 1.0 materials 1.1 body, coupling, and clamp nuts: steel. corro sion resistant per astm-a582. uns no. s30300. 1.2 center conductor: beryllium copper per astm-b196. uns c17300. 1.3 solder ferrule: bra ss per astm-b16. uns c36000. 1.4 lock ring: be ryllium copper per as tm-b197. uns c17200. 1.5 gasket and o-ring: si licone rubber per a-a-59588. 1.6 insulators: ptfe fluorocarbon pe r astm-d1710. 2.0 finishes 2.1 center contact and solder fe rrule: gold plate per astm-b488 50 microi nches min. thickness over electrolytic nickel plate per astm-b 689 50 microinches min. thickness. 2.2 body, coupling, and clamp nuts: passi vated per sae-ams-2700. 2.3 gasket, o-ri ng, and dielectr ic bead: none. 3.0 interface: type sm a plug per crystek interf ace specification cc-smap (meets mil-std-348. figure 310-1). note: distance from end of cable center conductor to ref. pl. is 0.289 page 1 of 2
12730 commonwealth drive ? fort myers, florida 33913 phone: 239-561-3311 ? 800-237-3061 fax: 239-561-1025 ? www.crystek.com crystek corporation microwave a division of crystek corporation product control: crystek part number: revision level: release date: responsible: a k. piotrowicz 04-jan-11 CS-SM-MHD note: distance from end of cable center conductor to ref. pl. is 0.289 1.1 trim cable as shown. step 1 2.1 slide clamp nut over cable as shown. 2.2 insert cable into solder ferrule as shown then solder br aids to ferrule where indicated. 2.3 trim exposed cable dielectric flush with solder ferrule face. 2.4 slide dielectric stop over cable center conductor against ferrule face and solder contact flush against stop to dimension shown. 2.5 slide forward in sulator onto contact. step 2 3.1 insert cable/contact sub- assembly into connector until seated and tighten clamp nut to 25-35 in-lbs. step 3 page 2 of 2 harbour ss402 cable
|
