gamewell-fci 12 clintonville road, northford, ct 06472-1610 us a ? tel: (203) 484-7161 ? fax: (203) 484-7118 specifications are for information only, are not intended for in stallation purposes, and are subj ect to change wi thout notice. no responsibility is assumed by gamewell-fci for their use. ?2008 honeywell international inc. all rights reserved. www.gamewell-fci.com 9020-0627 rev. c2 page 1 of 1 velociti ? series AOM-2SF addressable output relay supervised control module description velociti ? is a registered trademark of honeywell international inc. ul ? is a registered trademark of underwriters laboratories inc. the gamewell-f ci velociti ? series addressable output supervised control module (AOM-2SF) allows an gamewell-fci analog addressable fire alarm control to switch an external power supply, such as a dc supply or audio amplifier (up to 80 vrms) to notification appliances. the AOM-2SF notification appliance circuit can be wired either class a (style z) or class b (style y). it also super- vises the wiring to the connected loads and reports their status to the panel as normal, open or short cir- cuit. the module contains a panel controlled led. ? the velociti ? series use a communication protocol that substantially increases the speed of communication between the sensors and certain gamewell-fci analog addressable fire alarm controls. these devices operate in a grouped fashion. if one of the devices in the group has a status change, the panel?s mi croprocessor stops the group poll and concentrates on the single device. the net effect is response speed up to five times greater than earlier designs. the module is ul listed as suitable for releasing device service and fm approved for deluge and preaction ser- vice. refer to the gamewell-fci compatibility addendum, p/n 9000-0427, for a list of approved, compatible sole- noids. the AOM-2SF module is designed for installation in the signaling line circuit of any gamewell-fci analog addressable control panel. the signaling line circuits of gamewell-fci analog addressable control panels are designed to accommodate up to 159 modules per circuit. the AOM-2SF is designed to mount in a 4? (10.16 cm) square junction box 2 1/8? (5.5 cm) deep. relay contact ratings current rating maximum voltage load description application 3a 30 vdc resistive non-coded 2a 30 vdc resistive coded 0.9a 110 vdc resistive non-coded 0.5a 125 vac resistive non-coded 0.5a 30 vdc inductive (l/r=5ms) coded 1a 30 vdc inductive (l/r=2ms) coded 0.5a 125 vac inductive (pf=.35) non-coded 0.7a 75 vac inductive non-coded features ? compact size allows easy installation ? class a, style z, or class b, style y notification appliance circuit ? will accommodate audio amplifiers up to 80 v rms ? listed as suitable for releasing device service ? bicolor leds flash green whenever the module is addressed, and lights steady red on alarm* *note: only the red led is operative in panels that do not operate in velociti ? mode. specifications supervisory current: .000375 amps. alarm current: .0065 amps. operating temperature: 32 to 120 f (0 to 49 c) relative humidity: 10 to 93% relative humidity (non-condensing) dimensions: 4 1/2? h x 4? w x 1 1/4? d (11.4 h x 10.2 w x 3.2 d cm) ordering information model description AOM-2SF addressable output supervised control module an iso 9001-2000 company approved fm 30 23 5 94 signaling 07 3 0 0-0 6 9 4:1 7 8 s1949 me a ap pr o ved 227-03-e vol.iv AOM-2SF
|
