Part Number Hot Search : 
MAX405 1210E ZPY130 LT117 TCA705G SPE0523 TB120S TT570N
Product Description
Full Text Search
 

To Download HDH80-24B Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 H HiTRON
02/16/2004
ON-BOARD DC-DC CONVERTER QUARTER-BRICK BASE PLATE POWER MODULES INDUSTRIAL GRADE 48-110 WATTS SINGLE OUTPUT HDH80-24B OR 48B-S SERIES
FEATURES:
SINGLE OUTPUT WIDE 2:1 INPUT RANGE 1500VDC ISOLATION STANDARD QUARTER-BRICK PACKAGE HIGH-EFFICIENCY POWER MODULE UNDER-VOLTAGE LOCKOUT DESIGNED TO MEET INTERNATIONAL SAFETY STANDARDS
SPECIFICATION
INPUT SPECIFICATION
Input Range: Wide 2:1 Input DC Range 36-72Vdc or 18-36Vdc. Input Voltage: Nominal 48Vdc or 24Vdc. Input Current: Typical 2.35A full load and 0.1A no-load @ 48Vdc nominal input. Typical 4.14A full load and 0.05A no-load @ 48Vdc nominal input. Input Fuse: Use external fuse. Soft-Start: Installed. Inrush Current: Peak 2.38A @ 48Vdc & 4.3A @ 24Vdc. Input Filter: Pi-Network for EMI suppression. Under-Voltage Protection (UVP): Lock-out activated at 34-35.5Vdc input @48Vdc nominal input. 17.5-17.8Vdc input @24Vdc nominal input. Input OVP: 74-76Vdc @ 48Vdc nominal input. 37-38Vdc @24Vdc nominal input. Input Reflected Ripple Current: 8.0mA pk-pk @48 Vdc. Isolation Voltage: 1,500Vdc input-output. Remote On/Off: TTL/CMOS-Compatible input control. Positive Logic version for Standard set up: ON(Enable)=Open(or 2.5-5.0Vdc above-Vin) OFF(Disable)=Short(or 0-0.8Vdc above-Vin) Negative Logic version option available by adding a "N" suffix to the end of Model #.
Remark: Voltage refer to -Input (-Vin).
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: 48-110W typical continuous. Line Regulation: 0.1% typical. Load Regulation: Various with output voltage. 0.5% typical. Noise & Ripple: 1% rms typical. OVP: Built-in (latch). Adjustability: Factory set. Maybe externally trimmed with fixed resistor or trim pot. Overload Protection (OLP): Fully protected against output overload and short circuit. OLP set at about 125-150% rating output wattage. Consult the factory for OLP setting.
GENERAL SPECIFICATION
Efficiency: 88-90% typical, various with input & output. Switching Frequency: Fixed frequency 330K Hz. Circuit Topology: 330K Hz. Forward Circuit. Transient Response: Peak transient 150mV and recovers within 2mS after 25% load-change. Safety Standard: IEC60950 Class II. Case: Aluminum base plate with metal standoffs. Power Density: 29-66 Watts / Cubic inch typical. Industrial Grade. Operating Temperature: -40 to +100C (base plate) Power derating details please refer to the Derating Chart. Storage Temperature: -55 to +125 C. Temperature Coefficient: 0.02%/C. Humidity: Up to 95% RH, Non-Condensing. Cooling: At least 100LFM moving air is recommended for full load > +25C room temperature in a confined area. Air flow vs. Power derating details, please refer to the Derating Chart.
NOTE: (1) All measurements are at nominal input, full load, and +25C unless otherwise spec. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full-Load (F-L) to Half-Load(H-L)at nominal input. (4) Correct fuse size by calculating the max. DC current drain at low Line input & adding 20-25% for desired fuse size. Due to requests in market and advances in technology, specifications subject to -35 change without notice.
INPUT/OUTPUT & VOLTAGE/CURRENT RATINGS CHART
SINGLE OUTPUT
MODEL NO. HDH80-48B-S018250 HDH80-48B-S025250 HDH80-48B-S033220 HDH80-48B-S050200 HDH80-48B-S150060 HDH80-24B-S018250 HDH80-24B-S025250 HDH80-24B-S033220 HDH80-24B-S050200 HDH80-24B-S150060 INPUT Vdc Range Nominal 36-72Vdc 48Vdc 36-72Vdc 48Vdc 36-72Vdc 48Vdc 36-72Vdc 48Vdc 36-72Vdc 48Vdc 18-36Vdc 24Vdc 18-36Vdc 24Vdc 18-36Vdc 24Vdc 18-36Vdc 24Vdc 18-36Vdc 24Vdc OUTPUT VO1 # TYP. 25A 25A 22A 20A 6A 25A 25A 22A 20A 6A VOLT. 1.8Vdc 2.5Vdc 3.3Vdc 5.0Vdc 15.0Vdc 1.8Vdc 2.5Vdc 3.3Vdc 5.0Vdc 15.0Vdc MAX. 27.0A 27.0A 25.0A 22.0A 6.1A 27.0A 27.0A 25.0A 22.0A 6.1A PEAK 30.0A 30.0A 27.0A 25.0A 6.2.0A 30.0A 30.0A 27.0A 25.0A 6.2.0A
02/16/2004
Symbols: "" OVP built-in. "#" Remote sensing. "" Synchronous Rectifier. Remarks: Peak output, less than 60Sec. With duty cycle <10%.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 40.0g (1.4 Oz.) PIN ASSIGNMENT
PIN NO. PIN #1. PIN #2. PIN #3. PIN #4. PIN #5. PIN #6. PIN #7. PIN #8. SINGLE INPUT REMOTE ON/OFF +48V RETURN COMMON -SENSE VO1 ADJ. +SENSE +VO1
DERATING CHART
-36-


▲Up To Search▲   

 
Price & Availability of HDH80-24B

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X