View AWT6301M9P8_1214938.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

Cellular Dual Mode AMPS/CDMA 3.4 V/28 dBm Linear Power Amplifier Module
ADVANCED PRODUCT INFORMATION - Rev 0.1
AWT6301
FEATURES

InGaP HBT Technology High Efficiency: 53 % AMPS, 39 % CDMA Low Quiescent Current: 50 mA
Low Leakage Current in Shutdown Mode: <1 mA VREF = +2.85 V (+2.7 V Min Over Temp.) Optimized for a 50 W System Low Profile Surface Mount Package: 1.1mm CDMA 1XRTT, 1xEV-DO Compliant Pinout Enables Easy Phone Board Migration From 4mm x 4mm Package
APPLICATIONS

Single Mode CDMA Wireless Handsets
Dual Mode AMPS/CDMA Wireless Handsets
M9 Package 8 Pin 3mm x 3mm Surface Mount Module
art reliability, temperature stability, and ruggedness. Selectable bias modes that optimize efficiency for different output power levels, and a shutdown mode with low leakage current, serve to increase handset talk and standby time. The self contained 3mm x 3mm surface mount package incorporates matching networks optimized for output power, efficiency and linearity in a 50 W system.
PRODUCT DESCRIPTION
The AWT6301 meets the increasing demands for higher efficiency and linearity in AMPS/CDMA 1X handsets, while reducing pcb area by 44%. The package pinout was chosen to enable handset manufacturers to switch from a 4mm x 4mm PA module with very few layout changes to the phone board. The device is manufactured on an advanced InGaP HBT MMIC technology offering state-of-the-
GND at slug (pad) VREF
1 Bias Control 8
GND
VMODE 2
7
RFOUT
RFIN
3
6
GND
VCC1 4
Figure 1: Block Diagram
10/2003
5
VCC2
AWT6301
GND VREF 1 8 GND
VMODE
2
7
RFOUT
RFIN
3
6
GND
VCC1
4 GND
5
Figure 2: Pinout (X-ray Top View)
VCC2
Table 1: Pin Description
PIN 1 2 3 4 5 6 7 8 NAME VREF VMODE RFIN V CC1 V CC2 GND RFOUT GND DESCRIPTION Reference Voltage Mode Control RF Input Supply Voltage Supply Voltage Ground RF Output Ground
2
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
AWT6301
ELECTRICAL CHARACTERISTICS
Table 2: Absolute Minimum and Maximum Ratings PAR AME T E R Supply Voltage (VCC ) Wi th RF Dri ve DC Only Mode Control Voltage (VMODE) Reference Voltage (VREF) RF Input Power (PIN) Storage Temperature (TSTG) MIN 0 0 0 0 -40 M AX +5 +8 +3.5 +3.5 +10 +150 U N IT
V V V dBm C
Stresses in excess of the absolute ratings may cause permanent damage. Functional operation is not implied under these conditions. Exposure to absolute ratings for extended periods of time may adversely affect reliability.
Table 3: Operating Ranges
PAR AME T E R Operati ng Frequency (f) Supply Voltage (VCC) Reference Voltage (VREF) Mode Control Voltage (VMODE) RF Output Power (POUT) Case Temperature (TC)
MIN 824 +3.2 +2.7 0 +2.5 0 30.5(1) 27.5(1) -20
T YP +3.4 +2.85 +2.8 31.0 28.0 -
M AX 849 +4.2 +3.1 +0.5 +3.1 +0.5 +85
U N IT MHz V V V dBm C
C OMME N T S
PA "on" PA "shut down" Low Bi as Mode Hi gh Bi as Mode AMPS CDMA
The device may be operated safely over these conditions; however, parametric performance is guaranteed only over the conditions defined in the electrical specifications. Notes: (1) For operation at TC = +85 C and VCC = +3.2 V, POUT is derated by 0.5 dB.
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
3
AWT6301 Table 4: Electrical Specifications - AMPS Operation (TC = +25 C, VCC = +3.4 V, VREF = +2.85 V, VMODE = 0 V, POUT = +31 dBm, 50 W system)
PAR AME T E R Gai n Gai n Vari ati on Power-Added Effi ci ency Qui escent Current (Icq) Reference Current Mode Control Current Leakage Current Noi se i n Recei ve Band Harmoni cs 2fo 3fo, 4fo Input Impedance Spuri ous Output Level (all spuri ous outputs) MIN 25 23.5 50 T YP 27 27 0.3 53 100 5.0 0.35 <1 -134 -35 -50 M AX 30 31 1.0 120 8 1.0 5 -132 -30 -30 2:1 U N IT dB dB % mA mA mA mA dBm/Hz dBc VSWR POUT < +31 dBm Load VSWR < 8:1 Appli es over all voltage and temperature operati ng ranges VCC = +5.0 V PIN = +5 dBm Appli es over full operati ng temperature ranges VMODE = 0 V, Hi gh Bi as through VREF pi n through VMODE pi n VCC = +4.2 V, VREF = 0 V, VMODE = 0 V 869 MHz to 894 MHz C OMME N T S Over Temperature Over Temperature
-
-
-65
dBc
Load mi smatch stress wi th no permanent degradati on or fai lure
8:1
-
-
VSWR
4
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
AWT6301 Table 5: Electrical Specifications - CDMA Operation (TC = +25 C, VCC = +3.4 V, VREF = +2.85 V, 50 W system)
PAR AME T E R MIN 26 24.5 24 23 T YP 28 28 26 26 M AX 30 31 28 29 U N IT C OMME N T S POUT = +28 dBm, VMODE = 0 V Over Temperature POUT = +16 dBm, VMODE = +2.85 V Over Temperature
Gai n
dB
Adjacent Channel Power at 6885 kHz offset (1) Pri mary Channel BW = 1.23 MHZ Adjacent Channel BW = 30 kHz
-
-50 -50 -
-47 -44 -46 -44
dBc
POUT = +28 dBm, VMODE = 0 V Over Temperature POUT = +16 dBm, VMODE = +2.85 V Over Temperature
Adjacent Channel Power at 61.98 MHz offset (1) Pri mary Channel BW = 1.23 MHZ Adjacent Channel BW = 30 kHz
37 8 -
-60 -68 39 8.5 50 5 0.35 <1 -135 -35 -50 -
-57 -57 60 8 1.0 5 -133 -30 -30 2:1
dBc
POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V Over Temperature POUT = +28 dBm, VMODE = 0 V POUT = +16 dBm, VMODE = +2.85 V VMODE = 0 V, Low Bi as through VREF pi n through VMODE pi n VCC = +4.2 V, VREF = 0 V, VMODE = 0 V 869 MHz to 894 MHz
Power-Added Effi ci ency (1) Qui escent Current (Icq) Reference Current Mode Control Current Leakage Current Noi se i n Recei ve Band Harmoni cs 2fo 3fo, 4fo Input Impedance Spuri ous Output Level (all spuri ous outputs)
% mA mA mA mA dBm/Hz dBc VSWR
-
-
-65
dBc
POUT < +28 dBm Load VSWR < 8:1 Appli es over all voltage and temperature operati ng ranges VCC = +5.0 V PIN = +5 dBm Appli es over full operati ng temperature ranges
Load mi smatch stress wi th no permanent degradati on or fai lure
8:1
-
-
VSWR
Notes: (1) PAE and ACP limit applies at 836.5 MHz.
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
5
AWT6301
APPLICATION INFORMATION
To ensure proper performance, refer to all related Application Notes on the ANADIGICS web site: http://www.anadigics.com Shutdown Mode The power amplifier may be placed in a shutdown mode by applying a logic low levels (see Operating Ranges table) to both the VREF and VMODE voltages. Bias Modes The power amplifier may be placed in either a Low Bias mode or a High Bias mode by applying the appropriate logic level (see Operating Ranges table) to the VMODE voltage. The Bias Control table lists the recommended modes of operation for various applications.
Table 6: Bias Control
AP P L IC AT ION AMPS CDMA - low power CDMA - high power Shutdown
P OU T LEVELS (all) <+16 dBm >+16 dBm -
B IAS MOD E High Low High Shutdown
V R EF +2.85 V
V MOD E 0V
+2.85 V +2.85 V +2.85 V 0V 0V 0V
6
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
AWT6301
PACKAGE OUTLINE
Figure 3: M9 Package Outline - 8 Pin 3mm x 3mm Surface Mount Module
Figure 4: Branding Specification
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
7
AWT6301
COMPONENT PACKAGING
Figure 5: Tape & Reel Packaging
Table 7: Tape & Reel Dimensions
PACKAGE TYPE 3mm X 3mm TAPE WIDTH 12mm POCKET PITCH 4mm REEL CAPACITY 2500 MAX REEL DIA 13"
8
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
AWT6301
NOTES
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003
9
AWT6301
ORDERING INFORMATION
OR D E R N U MB E R T E MP E R AT U R E R AN GE -30 C to +110 C PAC K AGE D E S C R IP T ION 8 Pi n 3mm x 3mm Surface Mount Module C OMP ON E N T PAC K AGIN G
AWT6301M9P8
Tape and Reel, 2500 pi eces per Reel
ANADIGICS, Inc.
141 Mount Bethel Road Warren, New Jersey 07059, U.S.A. Tel: +1 (908) 668-5000 Fax: +1 (908) 668-5132 URL: http://www.anadigics.com E-mail: Mktg@anadigics.com IMPORTANT NOTICE
ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice. The product specifications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to change prior to a products formal introduction. Information in Data Sheets have been carefully checked and are assumed to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers to verify that the information they are using is current before placing orders.
ANADIGICS products are not intended for use in life support appliances, devices or systems. Use of an ANADIGICS product in any such application without written consent is prohibited.
WARNING
10
ADVANCED PRODUCT INFORMATION - Rev 0.1 10/2003

▲Up To Search▲

Price & Availability of AWT6301M9P8

	To Download AWT6301M9P8 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .