|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
BCM53718/BCM53718S (R) 48-Port GbE + Optional 2-Port GbE Highly Integrated Multilayer Switch SOC FEATURES * Highest silicon integration level achieved for a 48-port, 10/100/1000 Mbps Ethernet switch device SUMMARY OF BENEFITS * Single chip switch (SoC) optimized for the value driven small and medium-size business (SMB) market * Optional two 1 GbE Uplink ports (53718S) * Tenth-generation switch-on-a-chip (SoC) * Integrated MACs (IEEE 802TM. x compliant) with support for 9216-byte jumbo frames * Bill of Material (BOM) optimized with integrated CPU * Wirespeed performance * Eight flexible Class of Service (CoS) queues per port assure the lowest latency to high-priority traffic. This supports a wide variety of delay-sensitive video and audio multicast applications. * Integrated SGMII/SerDes interfaces * Non-blocking Gigabit Ethernet fully integrated switch fabric with 4-Mbit packet buffer memory * IEEE 802.3ad link aggregation increases effective bandwidth and provides link redundancy. * Integrated high-performance MIPS (R) processor for Web SmartTM applications * Storm and bandwidth/rate control provide improved traffic profile management. * Packet classification using four IEEE 802.1p Quality of Service (QoS) or DiffServ/TOS priority queues * Internet Protocol Version (IPv6) support provides future proofing. * Supports 4K IEEE 802.1Q VLAN * Supports up to 8K unicast MAC addresses * Supports MAC-based port aggregation (trunking) * Supports Access Control List (ACL) host table * Full- (IEEE 802.3x) and half-duplex flow control * Supports automatic address learning and aging * Supports Spanning Tree and Rapid Spanning Tree * Supports IEEE 802.1x MAC security * Port-based rate control with 1 Mbps granularity * Low-power 0.13 m CMOS core * Power dissipation 8.1W * 1292-Pin Flip-Chip Ball Grid Array (FCBGA) Package * Supports essential features for access applications * Includes Broadcom's WebSuperSmartTM software, an advanced Web-based network management solution * Includes advanced security and ease-of-use features such as Auto-DoS, Auto-VoIP, and Auto-ACL BCM53718/BCM53718S OVERVIEW Optional 2 x 1G Uplink (53718S) 1000 MAC L2 Switching Engine DoS Engine Integrated MIPS Processor Packet Buffer NMU ContentAwareTM Filter Processor 48 x 10/100/1000 MACs ...48 GbE SerDes Cores 48-Port Gigabit Ethernet Multilayer Switch The BCM53718 series is a complete L2 SoC solution for easy and rapid development of Gigabit switching applications. The BCM53718 series uses a WebSuperSmart graphical user interface (GUI) for system configuration of supported features. The BCM53718 integrates 48 configurable 1-Gbps ports or 10-Mbps/100-Mbps Ethernet ports, with the BCM53718S adding support for two Gigabit uplink ports. The BCM53718 series is a highly integrated solution ideally suited for stand-alone Gigabit Ethernet switches. It combines all the functions of a high-speed switch system, including packet buffers, SerDes, media access controllers, address management, a non-blocking switch fabric, and integrated high-performance CPU into a single 0.13 m CMOS device. The BCM53718 series supports auto-DoS attack prevention and SNMP, IEEE 802.1x, Spanning Tree, and Rapid Spanning Tree protocols. The BCM53718 switch: * Integrates internal memory in the Common Buffer Pool (CBP) for packet buffering. * Provides 48-full-duplex GbE ports that interface to external physical layer devices via the SerDes or SGMII interface. The GbE ports support both copper and fiber media. * Provides additional 2 x 1 GbE uplink ports for BCM53718S. * Supports a Broadcom serial control (BSC) controller for communicating with external devices such as serial EEPROM, flash PROM memories, and parallel port devices. * Supports a serial interface for the MII management of physical layer devices. * Supports an integrated MIPS processor for management functions with a DDR memory controller, a CMIC for switch access, parallel flash interface for booting, two serial UART interfaces, and eight GPIO pins. * Contains memory required to host L2 switching tables. * Supports VLAN double tagging via Gigabit ports. * Supports advanced QoS shaping for service provider networks. * Integrates sophisticated metering, statistics, and traffic management features, optimizing the QoS for voice, video, and data convergence. Ordering information: * BCM53718 (48 GbE + integrated CPU) * BCM53718S (48 GbE + 2 GbE Uplinks + integrated CPU) For additional ordering information, contact your Broadcom sales representative. Broadcom(R), the pulse logo, Connecting everything(R), and the Connecting everything logo are among the trademarks of Broadcom Corporation and/or its affiliates in the United States, certain other countries and/or the EU. Any other trademarks or trade names mentioned are the property of their respective owners. (R) BROADCOM CORPORATION 16215 Alton Parkway, P.O. Box 57013 Irvine, California 92619-7013 (c) 2006 by BROADCOM CORPORATION. All rights reserved. 53718_53718S-PB00-R 08/17/06 Phone: 949-450-8700 Fax: 949-450-8710 E-mail: info@broadcom.com Web: www.broadcom.com |
Price & Availability of BCM53718S |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |