View OFC5DJ3BS_471790.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com
PRODUCT
D AT A
SHEET
CRYSTAL CONTROLLED OSCILLATORS
OFC5DJ3BS CW 0534
SURFACE MOUNT 5.0V OCXO with SINEWAVE OUTPUT
ABSOLUTE M AXIMUM RATING S
PARAMETER Storage Temperature Supply Voltage UNITS (Vcc) MINIMUM -40 -0.5 NOMINAL MAXIMUM 85 7 UNITS C Vdc TABLE 1.0 NOTE
OFC5DJ3BS
TABLE 2.0 NOTE 1 2 3
OPERATING SPECIFIC ATIONS
PARAMETER Center Frequency Standard Frequencies Available: Frequency Calibration Frequency vs. Temperature Stability Frequency vs. Voltage Stability (+/-5%) Frequency vs. Load Stability (+/-5%) Aging: Daily Aging: First Year Aging: Long Term (20 Years) Total Frequency Tolerance (20 years) Allen Variance: 1 second, 100 average. Operating Temperature Range Supply Voltage Power Consumption: Turn On Power Consumption: Steady-State Start-Up Time Warm Up (Fo) MINIMUM 10 NOMINAL MAXIMUM 20 UNITS MHz
DESCRIPTION
(Vcc)
10 MHZ, 13 MHz, 15 MHZ, or 20 MHz -0.2 0.2 ppm -20 20 ppb -2 2 ppb -2 2 ppb -1 1 ppb/day -50 50 ppb -250 250 ppb -500 500 ppb 1.00E-10 RMS -20 70 C 4.75 5.00 5.25 Vdc 3.25 W 1. 5 W 500 mS -100 100 ppb
SINEWAVE OUTPUT CHARACTERISTICS
PARAMETER LOAD Output Power Spurious Output SSB Phase Noise at 1Hz offset SSB Phase Noise at 10Hz offset SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset MINIMUM 45 0 -
RESTABILIZATION TIME
Off Time < 1 Hour < 6 Hours < 24 Hours 1 to 16 Days > 16 Days
w
w
w
.D
NOMINAL 50 3 -85 -110 -135 -150 -155
t a
S a
MAXIMUM 55 -80 -
e h
UNITS Ohms dBm dBc dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz
t e
4 5 6 6 7 8 NOTE
U 4
The Connor-Winfield OFC5DJ3BS is a 5V Surface Mount Oven Controlled Crystal Oscillator (OCXO) with a Sinewave output. The OFC5J3BS is designed for Wireless applications requiring low Phase Noise and tight frequency stability.
.c
m o
FEATURES
TABLE 3.0
FIXED FREQUENCY OCXO FREQUENCY STABILITY: 20ppb TEMERATURE RANGE: -20 to 70C 5.0V OPERATION SINEWAVE OUTPUT
TABLE 4. 0 NOTE 9 9 9 9 9
Restabilization Time < 2 Hours < 12 Hours < 48 Hours 48 Hours + 1/4 Off Time < 6 Days
LOW PHASE NOISE SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING
10.00M
PACKAG E CHARACTERISTICS
Package
TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded metal cover. ENVIRONMNETAL CHARACTERISTICS TABLE 6.0 Shock 100G's, 6mS, halfsine per MIL-STD-202F, Method 213B, Test Condition C Vibration 0.06" D.A. or 10G peak 10 to 500 Hz, per MIL-STD-202F, Method 204D, Test condition A PROCESS RECOMMENDATIONS TABLE 7.0 Solder Reflow The component solder used internal to this device has a melting point of 221C. The peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds Wash Ultrasonic cleaning is not recommended.
DATA SHEET #:
Cx067
PAGE 1
OF
2
REV: 03
DATE:
10/04/05
w
aCopyright 2001 Connor-Winfield all rights reserved.
w
Specifications subject to change without notice.
Sh OFC5DJ3BS a at .D w
OCXO SERIES
ORDERING INFORMATION
et e
4U
.
om c
- 10.00MHz
CENTER FREQUENCY
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. www.conwin.com
PRODUCT
D AT A
SHEET
CRYSTAL CONTROLLED OSCILLATORS
TABLE 8.0
Notes: 1) 2) 3) 4) 5) 6) 7) 8) 9)
Labels will include the calibr ation frequency at the time of ship. Initial calibration @ 25C at the time of shipment. Overall frequency stability ref erenced to measurement at 25C. After ten days of continuous operation. Inclusive of calibration, freq uency stability vs. change in tem perature, supply voltage change, load change, hock and vibration, 20 years aging. Vcc = 5.0Vdc. From Vcc=90% of final value. No m ore than 16 transitions at start-up before oscillator has started. Measured @ 0C, within 5 minutes, refer enced one hour after turn-on. For a given off time, the time r equired to meet daily aging, short-term stability.
Pin 1 2 6 7 8 9 10 11 12 13 14 15 16
Function N/C Ground N/C Ground Vcc Vcc Ground Ground N/C Ground Output Ground N/C
Dimensional Tolerance: .005 (.127mm)
SUGGESTED PAD LAYOUT
12.7
DATE CODE
OFC5DJ3BS
.310 (7.87mm)
10.00M
CW
.210 (5.33mm)
.110 (2.75mm) .210 (5.33mm)
Pin 1
.110 (2.75mm)
KEEP OUT AREAS (3 PLACES)
Vcc
Vcc GND 7 NC 6
10 GND 11 GND 12 NC 13 GND 14 OUT 15 GND
NC
GND 2 NC
50 Ohm
Specifications subject to change without notice. DATA SHEET #: Cx067 PAGE 2 OF 2 REV: 03 DATE: 10/04/05
aCopyright 2001 Connor-Winfield all rights reserved.

▲Up To Search▲

Price & Availability of OFC5DJ3BS

	To Download OFC5DJ3BS Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .