|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers Features * Industry-standard driver replacement * Improved response times * Matched rise and fall times * Reduced clock skew * Low output impedance * Low input capacitance * High noise immunity * Improved clocking rate * Low supply current * Wide operating range * Separate drain connections General Description The EL7104C and EL7114C ICs are matched driver ICs that improve the operation of the industry-standard TC-4420/29 clock drivers. The Elantec versions are very high speed drivers capable of delivering peak currents of 1A into highly capacitive loads. The high speed performance is achieved by means of a proprietary "Turbo-Driver" circuit that speeds up input stages by tapping the wider voltage swing at the output. Improved speed and drive capability are enhanced by matched rise and fall delay times. These matched delays maintain the integrity of input-to-output pulse-widths to reduce timing errors and clock skew problems. This improved performance is accompanied by a 10-fold reduction in supply currents over bipolar drivers, yet without the delay time problems commonly associated with CMOS drivers. Applications * * * * * * * Clock/line drivers CCD drivers Ultrasound transducer drivers Power MOSFET drivers Switch mode power supplies Resonant charging Cascoded drivers Connection Diagrams V+ 1 8 V+ 7 P_OUT 6 N_OUT 5 GND EL7104C Non-inverting Driver Ordering Information Part No. EL7154CN EL7154CS Package 8-Pin PDIP 8-Pin SO Tape & Reel Outline # MDP0031 MDP0027 IN 2 NC 3 GND 4 V+ 1 IN 2 NC 3 GND 4 EL7114C Inverting Driver 8 V+ 7 P_OUT August 20, 2001 6 N_OUT 5 GND Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a "controlled document". Current revisions, if any, to these specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation. (c) 2001 Elantec Semiconductor, Inc. EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers Absolute Maximum Ratings (T Supply (V+ to GND) Input Pins Peak Output Current Storage Temperature Range Ambient Operating Temperature A = 25C) 16.5V -0.3V to +0.3V above V+ 4A -65C to +150C -40C to +85C Operating Junction Temperature Power Dissipation: SO PDIP +125C 570mW 1050mW Important Note: All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA. DC Electrical Characteristics TA = 25C, V+ = 15V unless otherwise specified. Parameter Input VIH IIH VIL IIL VHVS Output ROH ROL IOUT IPK IDC Power Supply IS VS Power Supply Current Operating Voltage Input = V+ EL7104C EL7114C 4.5 4.5 1 7.5 2.5 16 mA V Pull-Up Resistance Pull-Down Resistance Output Leakage Current Peak Output Current Continuous Output Current IOUT = -100 mA IOUT = +100 mA V+/GND Source Sink Source/Sink 200 1.5 2 0.2 4.0 4.0 4 4 10 A A mA Logic "1" Input Voltage Logic "1" Input Current Logic "0" Input Voltage Logic "0" Input Current Input Hysteresis @0V 0.1 0.3 @V+ 2.4 0.1 10 0.8 10 V A V A V Description Test Conditions Min Typ Max Unit AC Electrical Characteristics TA = 25C, V = 15V unless otherwise specified. Parameter tR tF tD-ON tD-OFF Rise Time Fall Time Turn-On Delay Time Turn-Off Delay Time Description Test Conditions CL = 1000 pF CL = 2000 pF CL = 1000 pF CL = 2000 pF See Timing Table See Timing Table Min Typ 7.5 10 10 15 18 18 20 25 25 20 Max Unit ns ns ns ns ns ns Switching Characteristics (VDD = VH = 12V; VL = -3V) 2 EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers Timing Table 5V Input 2.5V 0 Inverted Output EL7114C 90% 10% Noninverted Output 90% 10% tD1 tF tR tD2 tR tF Standard Test Configuration 1 2 D.U.T. 8 6 4.7F Input Signal 7 Output Signal 4 5 2000pF 3 EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers EL7104C Simplified Schematic EL7114C Simplified Schematic 4 EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers Typical Performance Curves Max Power/Derating Curves Switch Threshold vs Supply Voltage Peak Drive vs Supply Voltage Input Current vs Voltage Quiescent Supply Current "ON" Resistance vs Supply Voltage 5 EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers Average Supply Current vs Voltage and Frequency Rise/Fall Time vs Load Rise/Fall Time vs Supply Voltage Propagation Delay vs Supply Voltage Rise/Fall Time vs Temperature Rise/Fall Time vs Temperature 6 EL7104C, EL7114C EL7104C, EL7114C High Speed, Single Channel, Power MOSFET Drivers General Disclaimer Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the circuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described herein and makes no representations that they are free from patent infringement. WARNING - Life Support Policy Elantec, Inc. products are not authorized for and should not be used within Life Support Systems without the specific written consent of Elantec, Inc. Life Support systems are equipment intended to support or sustain life and whose failure to perform when properly used in accordance with instructions provided can be reasonably expected to result in significant personal injury or death. Users contemplating application of Elantec, Inc. Products in Life Support Systems are requested to contact Elantec, Inc. factory headquarters to establish suitable terms & conditions for these applications. Elantec, Inc.'s warranty is limited to replacement of defective components and does not cover injury to persons or property or other consequential damages. Printed in U.S.A. August 20, 2001 Elantec Semiconductor, Inc. 675 Trade Zone Blvd. Milpitas, CA 95035 Telephone: (408) 945-1323 (888) ELANTEC Fax: (408) 945-9305 European Office: +44-118-977-6020 Japan Technical Center: +81-45-682-5820 7 |
Price & Availability of EL7154CN |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |