| PART |
Description |
Maker |
| SR820R |
Schottky barrier rectifier. Case negative. Maximum recurrent peak reverse voltage 20 V. Maximum average forward rectified current 8.0 A.
|
Bytes
|
| LB8682PL |
Monolithic Digital IC For Camera Cell Phone Motor Driver Two Saturated Drive Channels and One Constant-Current Drive Channel
|
Sanyo Semicon Device
|
| SE-12A015C |
Solid State Relay Maximum Load Current 1.5 A
|
Fujitsu Quantum Devices Limited
|
| AD8500 |
precision CMOS op amp featuring a maximum supply current
|
Analog Devices
|
| HCPL-J314 HCPL-J314-300 HCPL-J314-500 HCPL-J314-XX |
0.4 Amp Output Current IGBT Gate Drive Optocoupler 0.4安培输出电流IGBT栅极驱动光电耦合
DB25 F/F NULL MODEM ADAPT SCA-
HCPL-J314 · 0.4 Amp Output Current IGBT Gate Drive Optocoupler
|
Ecliptek, Corp.
HP[Agilent(Hewlett-Packard)]
Agilent (Hewlett-Packard)
|
| 2SJ334 |
P CHANNEL MOS TYPE (HIGH SPEED, HIGH CURRENT SWITCHING, DC-DC CONVERTER, RELAY DRIVE AND MOTOR DRIVE APPLICATIONS) P通道马鞍山型（高速，大电流开关，DC - DC变换器，继电器驱动器和电机驱动应用）
|
Toshiba, Corp.
TOSHIBA[Toshiba Semiconductor]
|
| 2N6230 |
N FEMALE POWER DIVIDER; NUMBER OF OUTPUT PORTS: 2; FREQUENCY RANGE: 2 - 500 MHz; MINIMUM ISOLATION: 25 dB; VSWR: 1.35 MAXIMUM; MAXIMUM INSERTION LOSS
|
TT electronics Semelab Limited
|
| MCP6542 MCP6542-I/MS MCP6542-I/P MCP6542-I/SN MCP6 |
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current ...
Push-Pull Output Sub-Microamp Comparators
The MCP6544 is a Push-pull, quad comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the 16 lead PDIP, SOIC and 14 lead TSSOP pack
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package,
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC and MSOP package.
The MCP6541 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V, with typical quiescent current of 600 nA and a maximum of 1 microamp. This device is offered in the eight lead PDIP, SOIC, MSOP and five le
The MCP6543 is a Push-pull, single comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current ...
The MCP6542 is a Push-pull, dual comparator. This single-ended device operates from 1.6V to 5.5V,with typical quiescent current of ...
From old datasheet system
IC,VOLT COMPARATOR,DUAL,CMOS,TSSOP,8PIN,PLASTIC
|
Microchip Technology Inc.
|
| STK392-020 |
Convergence Correction Circuit Three Channel in a Single Package(Maximum Output Current:6A) 收敛校正电路的三通道（最大输出电流：6A在单一封装
|
Sanyo Electric Co., Ltd.
Sanyo Semicon Device
|
| FLTR100V10 FLTR100V10-62 FLTR100V10-62Z FLTR100V10 |
75 Vdc Input Maximum, 10 A Maximum
|
Lineage Power Corporation
|
| FLTR75V05 FLTR75V055Z FLTR75V058Z FLTR75V05Z FLTR7 |
75 Vdc Input Maximum, 5 A Maximum
|
Lineage Power Corporation
|
