| |
|
 |
ICST[Integrated Circuit Systems]
|
| Part No. |
MK3771-1
|
| OCR Text |
...K277X. These capacitors must be placed as close to the chip as possible. This is the minimum recommended configuration, and will give good results in most applications. For noisy power supplies, an additional 0.1F can be placed on pin 4, an... |
| Description |
USING MICROCLOCKS INTEGRATED VCXO PRODUCTS
|
| File Size |
109.86K /
6 Page |
 View
it Online |
Download Datasheet
|
| |
|
|
MPS[Monolithic Power Systems]
|
| Part No. |
MP1541_06 MP1541 MP1541DJ
|
| OCR Text |
...greater. This capacitor must be placed physically close to the IN pin. Since it reduces the voltage ripple seen at IN, it also reduces the amount of EMI passed back along that line to the other circuitry. Selecting the Output Capacitor A si... |
| Description |
1.3MHz Boost Converter
|
| File Size |
309.87K /
8 Page |
View
it Online |
Download Datasheet |
| |
|
|
MPS[Monolithic Power Systems]
|
| Part No. |
MP1541DJ MP1541
|
| OCR Text |
...greater. This capacitor must be placed physically close to the IN pin. Since it reduces the voltage ripple seen at IN, it also reduces the amount of EMI passed back along that line to the other circuitry. Selecting the Output Capacitor A si... |
| Description |
1.3MHz Boost Converter
|
| File Size |
239.02K /
8 Page |
View
it Online |
Download Datasheet |
| |
|
|
Monolithic Power System...
MPS[Monolithic Power Systems]
|
| Part No. |
MP1542_06 EV1542DK-00A MP1542 MP1542DK
|
| OCR Text |
...y ceramic 0.1F capacitor may be placed closer to the IC with the larger capacitor placed further away. If using this technique, it is recommended that the larger capacitor be a tantalum or electrolytic type. All ceramic capacitors should be... |
| Description |
700KHz/1.3MHz Boost Converter with a 2A Switch
|
| File Size |
452.46K /
10 Page |
View
it Online |
Download Datasheet |
| |
|
|
APEX[Apex Microtechnology]
|
| Part No. |
MP38A MP38
|
| OCR Text |
... 1F ceramic capacitor should be placed in parallel with each aluminum electrolytic capacitor. Both of these capacitors have to be placed as close to the power supply pins as physically possible. If not connected to the Vs pins (See BOOST OP... |
| Description |
POWER OPERATIONAL AMPLIFIER
|
| File Size |
216.96K /
4 Page |
View
it Online |
Download Datasheet |
| |
|
|
MOTOROLA[Motorola, Inc]
|
| Part No. |
MPXY8021A6U MPXY8021A MPXY8021A6T1
|
| OCR Text |
... the VDD pin the device will be placed into its Trim/ Test Mode. NOTE: If the VDD supply source is switched off in order to reduce current consumption, it is important that all input pins be driven LOW to avoid powering up the device. If an... |
| Description |
Tire Pressure Monitoring Sensor
|
| File Size |
257.31K /
16 Page |
View
it Online |
Download Datasheet |
|
Price and Availability
|
